Forum Discussion

sohailalam2696's avatar
sohailalam2696
Contributor
2 years ago

Session Creator

So, I have a quick question, I know what following command does, but may I please know where should I put the below command? Is it going to be at the end of execution plan or should it be directly wr...
Integrations
Keyword Tests
web testing
  • rraghvani's avatar
    rraghvani
    2 years ago

    As mentioned in the documentation, "The RunTest command opens an interactive user session (or connects to an existing session) using the specified credentials and runs the specified TestComplete test."

     

    If you are using a VM, and you type in a command such as DIR C:\ in the Command Prompt, it will produce a directly listing of the C: drive of your VM. The same applies if you were to run SessionCreate.exe from the Command Prompt, it will run the application on your VM - assuming you have TestExecute installed on the VM.

     

    I suggest you read through Running Tests via Remote Desktop to understand running tests.

rraghvani's avatar
rraghvani
Champion Level 3
2 years ago

As mentioned in the documentation, "The RunTest command opens an interactive user session (or connects to an existing session) using the specified credentials and runs the specified TestComplete test."

 

If you are using a VM, and you type in a command such as DIR C:\ in the Command Prompt, it will produce a directly listing of the C: drive of your VM. The same applies if you were to run SessionCreate.exe from the Command Prompt, it will run the application on your VM - assuming you have TestExecute installed on the VM.

 

I suggest you read through Running Tests via Remote Desktop to understand running tests.