Forum Discussion

bdrummond's avatar
bdrummond
Contributor
7 years ago

How do I manually map an invisible object such as 'Docking Hint'...?

Hi all,   After a length of good run of using Test Complete version 14.20, I have come across another obstacle for my testing procedure.   How do I manually map an invisible object such as 'Docki...
  • bdrummond's avatar
    bdrummond
    7 years ago

    Great stuff,

     

    Although I have the object namemapped, I come across (with luck) a method which I no longer need that 'DockingHint' object anymore.

     

    Instead, I have a property of the Toolbox called 'Dock [Set]' and set it's value to either "left" or "right". This method allow me to command my application to redock that toolbox accordingly : )

     

    Thanks again for your help.

     

    BD

  • bdrummond's avatar
    bdrummond
    Contributor
    7 years ago

    Hi tristaanogre,

     

    Thank you for your reply and superbly simple answer. I am amazed how I missed that method of namemapping completely. The object in question is now able to be added to the namemapping list. see the first image.

     

    But, I was wondering if you could give me some insight to what the warning message mean when I try to save the object mapping. see the second image.

     

    Thanks very much.

     

    BD

    • tristaanogre's avatar
      tristaanogre
      Esteemed Contributor
      7 years ago

      Yes.

       

      "Name" should not be used as a property for mapping.  Basically, by using the "Name" property, you're bypassing the NameMapping engine so there's risk that identification might not be as clean.  The warning is basically saying that there is such a risk.  

       

      I would choose a property other than "Name".  Perhaps simply replace it with the ObjectType property.

      • bdrummond's avatar
        bdrummond
        Contributor
        7 years ago

        Great stuff,

         

        Although I have the object namemapped, I come across (with luck) a method which I no longer need that 'DockingHint' object anymore.

         

        Instead, I have a property of the Toolbox called 'Dock [Set]' and set it's value to either "left" or "right". This method allow me to command my application to redock that toolbox accordingly : )

         

        Thanks again for your help.

         

        BD