Hi,
This could be a timing issue.
What you can do is, Try to identify a object which loads at last and Use WaitChild to wait until the Objects exists or Visible. Then perform your testing.
Also below might help you
Hi,
This could be a timing issue.
What you can do is, Try to identify a object which loads at last and Use WaitChild to wait until the Objects exists or Visible. Then perform your testing.
Also below might help you
Hi Shankar,
I've had some success with getting controls recognised, by using the "Exists" object method. Am sure WaitChild would give same results so thanks for pointing me in right direction.
I'm curious about something though, why would a adding a delay to a test not give the same result? I added a 60 second delay to my tests which did not allow the object to be found, but when I added the "Exists" method to a object on the page, my test object was found and the test proceeded.
Can you explain why simply delaying the test might not have been sufficient. I'd love the understand what the difference is between simplying adding a delay to allow objects to load and adding the object "Exists" check.
