My test set disappears after unlinking from a release
- Took some tests (tests were linked to a requirement) & created a Test Set out of them (ID # 330406)
- As creating the test set, removed the link from the release before I submitted
- Went to Test Set, saw the set I created, viewed it and the link is back
- Unlink it again
- Result: Test set is gone
- Did over this time unlinked requirement from test cases before creating test set
- Then unlinked release as creating test set before submitting
- Result: Test set is nowhere to be found
Must I have a link when creating a test set?
Hi Sheilagh,
Items displayed in the Listing can be filtered in several ways (by Release, by Folder, by a custom criterion specified in the selected Filter, etc.). I've noticed, that you have a filter by Release: https://www.screencast.com/t/W0sCrjroajP7. Please set the Release value to All Releases (select the root on the Releases tab) and look for the Test Set once again. Since you unlink the Test Set from a Release, it isn't displayed with the set Release Filter.
Also, you can check the following:
1. Make sure the correct "Project:" is selected.
2. Make sure "Releases:" shows "(All Releases)".
3. Make sure "Type:" shows "(All Types)".
4. Make sure "(No Filter)" is enabled.
5. Make sure you are in the correct "Folder".
6. Make sure "Show Inactive Test Sets" under the "Actions" drop down is checked or unchecked (depending on this, one is able or not able to see inactive tests).
See the example video here: http://screencast.com/t/C34VMI6Rs2A.
sheba0907 wrote:Must I have a link when creating a test set?
No, it isn't required.
