Forum Discussion

Raghukatta's avatar
Raghukatta
Contributor
7 years ago

Conditional name mapping not working in test execute

Hi,

I created conditional name mapping few objects. It is working in test complete but not able to identify conditional mapping when I run with test execute. Same scripts were working fine till last week with both test complete and test execution. Not able to figure it out why it is not working now. Are there any settings to enable that? 

Thank you in advance!

 

  • tristaanogre's avatar
    tristaanogre
    7 years ago

    There is no particular setting to turn on or off conditional NameMapping.

     

    However, from TC 12.4x to TC 12.5, there were some changes made in how data is stored in NameMapping, specifically for Conditional NameMapping.

    So, if your TestComplete version and TestExecute versions are mismatched, this could be the cause.  Double check your versions.  

    If not, we can proceed further but that's the first thing I'd check.

  • tristaanogre's avatar
    tristaanogre
    7 years ago

    Yeah... you need to upgrade your TestExecute to 12.50.  While, for the most part, minor version upgrades don't require upgrading across the board, it is strongly recommended to do so and, in this case, while not OFFICIALLY required by SmartBear, if you're using Conditional NameMapping, you need to keep your version consistent.

     

     

  • tristaanogre's avatar
    tristaanogre
    Esteemed Contributor
    7 years ago

    There is no particular setting to turn on or off conditional NameMapping.

     

    However, from TC 12.4x to TC 12.5, there were some changes made in how data is stored in NameMapping, specifically for Conditional NameMapping.

    So, if your TestComplete version and TestExecute versions are mismatched, this could be the cause.  Double check your versions.  

    If not, we can proceed further but that's the first thing I'd check.

    • Raghukatta's avatar
      Raghukatta
      Contributor
      7 years ago

      Thank you Tristaanogre. Yes, my test execute version is 12.42 and test complete version is  TC 12.5. Looks like that is the issue.

      • tristaanogre's avatar
        tristaanogre
        Esteemed Contributor
        7 years ago

        Yeah... you need to upgrade your TestExecute to 12.50.  While, for the most part, minor version upgrades don't require upgrading across the board, it is strongly recommended to do so and, in this case, while not OFFICIALLY required by SmartBear, if you're using Conditional NameMapping, you need to keep your version consistent.