Forum Discussion
- baxatobCommunity Hero
Can you show the code from the Unit1 script?
- tristaanogreEsteemed ContributorIs Test Executive running on the same machine? If not, have you checked to make sure that the Namemapping file was properly transferred to the new machine?
- NeelOccasional Contributor
Hi,
If I'm running the same code using Test Execute 12, then I'm able to use aliases in my code, but the problem remain same if I'm using Test Execute 10. Thank you for your help and support :)
- Colin_McCraeCommunity Hero
Hold on.
Your code was developed in TestComplete v12 right?
In which case, it will not run in TestExecute v10.
You can't run code from a newer version in an older one.....
- NeelOccasional Contributor
i have developed code in TestComplete 10 only, and able to run in TestExecute 12.
- Colin_McCraeCommunity Hero
OK.
I think the sequence here may be important.
So ....
Project developed in TC10.
Project runs in TE12.
Project will not run in TE10.
What order did you run them in?
HKosova .... may be able to confirm here, but if you run a TC10 project in TE12, it may well update it to TE12 standards. Which would then prevent it running on TE10? Sounds plausible to me.
But if you develop it in TC10.
Run it on TE10, it should be OK.
Run it on TE12, it should still be OK.
But then go back to TE10, it no longer runs.
Would confirm it.
- NeelOccasional Contributor
I'm following beolow sequence:
Developed it on TC10.
Ran it on TE10, wasn't working.
Ran it on TE12, was working fine.
- Colin_McCraeCommunity Hero
OK. That's weird. Think you'll need to contact support on this one cos the sequence you posted looks like it should be OK to me ...
Related Content
- 3 years ago
- 2 years ago
- 5 years ago
Recent Discussions
- 44 minutes ago
- 21 hours ago