Forum Discussion

Bjorn_Kruuse-Me's avatar
Bjorn_Kruuse-Me
Occasional Contributor
10 years ago

Reboot remote computer while running distibuted test

Hi I have a project where I control several remote computers in a distributed test. One of the first steps is to install software, then reboot the computers. After this I want to continue running...
  • TanyaYatskovska's avatar
    TanyaYatskovska
    10 years ago

    Hi Bjørn,

     

    You need to investigate the Action after run option of your task. You can set it to Reboot computer – in this case, TestComplete will reboot the slave computer. Please read the Editing Task Properties ( http://smartbear.com/viewarticle/68430/ ) article for details.

     

    Is this that you were looking for?

TanyaYatskovska's avatar
TanyaYatskovska
SmartBear Alumni (Retired)
10 years ago

Hi Bjørn,

 

You need to investigate the Action after run option of your task. You can set it to Reboot computer – in this case, TestComplete will reboot the slave computer. Please read the Editing Task Properties ( http://smartbear.com/viewarticle/68430/ ) article for details.

 

Is this that you were looking for?

  • Bjorn_Kruuse-Me's avatar
    Bjorn_Kruuse-Me
    Occasional Contributor
    10 years ago

    Hi Tanya.

     

    Thanks for your answer.

     

    It was so simple that it did not occure to me to look there.

    I was looking into some scripting objects to do it.

     

    (Explains why I did not find anybody else looking for this when googeling:smileyvery-happy:)

     

    Regards

    Bjørn Kruuse-Meyer