Forum Discussion
ssachinshanbhag
14 years agoNew Contributor
The OnLogError method is not helping my cause.
I have followed the steps in other articles regarding this. My test suite still continues to abort.
Just to clarify further, attached 3 snapshots as given below -
Proj_properties - Showing my project properties in which show on error and error
dialog are disabled
testitem_Properties - Showing my test items and properties set to NONE so that
it can continue to run its siblings
errorLog - When my test suite hits error/exception "undefined variable", it
aborts the whole project without running other testitems. Also if you notice
that "extended message", it still says my testitem setting is set to "Test Item"
and not None. Dont know why?.
Apart from this, do I need to set any other information? Or if you need any
further information, please let me know so that this problem can be resolved.
I have followed the steps in other articles regarding this. My test suite still continues to abort.
Just to clarify further, attached 3 snapshots as given below -
Proj_properties - Showing my project properties in which show on error and error
dialog are disabled
testitem_Properties - Showing my test items and properties set to NONE so that
it can continue to run its siblings
errorLog - When my test suite hits error/exception "undefined variable", it
aborts the whole project without running other testitems. Also if you notice
that "extended message", it still says my testitem setting is set to "Test Item"
and not None. Dont know why?.
Apart from this, do I need to set any other information? Or if you need any
further information, please let me know so that this problem can be resolved.
Related Content
Recent Discussions
- 4 hours agoJacobjacob44