OK, yes, I was wrong. There doesn't appear to be such a setting.
However, question: Your application... are you using it as a Tested Application in TestComplete? If so, what do you have your "Run Mode" set to?
Edit: found it. It is set to simple.
OK, then that's not it.
I'm running short on ideas here. But I think my initial suspicion is correct, even though the cause might not be: That being that your "close application" call is closing it but then some other "hook"; is in the application that, is attempting to perform some sort of action that is subsequently failing and being reported as a crash.
Looking at your code for your close routine, I see that you're closing it but then doing some additional checks to determine if the close completed successfully and, if it hasn't, to perform some other checks and try closing by implementing a button click. So, I wonder, in your log, if you double click on the error, where does that take you? Is it taking you to a particular line of code somewhere?
