Forum Discussion

Actinomorphic's avatar
Actinomorphic
Occasional Contributor
6 years ago

If Object Auto-wait timeout not working

In the above image, the keyword test runs fine as long as I have the Delay preceding the highlighted If Object test action. If I remove the delay and instead set the Auto-wait Timeout of the h...
  • Actinomorphic's avatar
    Actinomorphic
    6 years ago

    Thanks for the replies and ideas folks. It turned out that the FormEZWizard didn't actually even exist in the mode the SetupScreen was in at the time, so I added an IfObject Exists ahead of the IfObject Visible and it works fine now.

     

Marsha_R's avatar
Marsha_R
Moderator
6 years ago

If the other If Object - Visible lines in your test are working properly, then I would contact Support about this issue.  Here's the link: https://support.smartbear.com/message/?prod=TestComplete

 

If none of them are working, I would suspect a timing issue.  Try using the Debug function and step through one that isn't working so you can see what TestComplete sees at each point.