cannot run Sys. commands from my machine
We have three people using Testcomplete 8 in our office and two of them can run Sys. commands but my testcomplete won't. I have to use the name mapped script. ex: they can run Sy...
Forum Discussion
On a hunch (don't know if this will fix it), there's an environmental setting that is machine specific, not project level.
Go to Tools | Options | Engines | General. There's a check flag that says "Use short names when possible". Compare that setting between your machine and your co-workers' machines. This SEEMS to be affecting the same stuff, but I can't be sure.
Also, on the same lines, the option mentioned above for "Map object names automatically" is an environment level item and not a project level item. That's found under Tools | Options | Engines | NameMapping. Again, compare that setting among your machines.
Beyond that, I'm not sure where else to look. Perhaps an official SmartBear person might have a better idea of what to check if these ideas don't work.
Go to Tools | Options | Engines | General. There's a check flag that says "Use short names when possible". Compare that setting between your machine and your co-workers' machines. This SEEMS to be affecting the same stuff, but I can't be sure.
Also, on the same lines, the option mentioned above for "Map object names automatically" is an environment level item and not a project level item. That's found under Tools | Options | Engines | NameMapping. Again, compare that setting among your machines.
Beyond that, I'm not sure where else to look. Perhaps an official SmartBear person might have a better idea of what to check if these ideas don't work.