Forum Discussion

mcastellanos's avatar
mcastellanos
Occasional Contributor
10 years ago

Call using USEUNIT in vbscript does not work

I have function1(param1) defined in script Unit1 and I want to call function1(param1) from script Unit2. Thus, I have done the following according to documentation:   'In Unit2 script, did '''''''...
  • Colin_McCrae's avatar
    Colin_McCrae
    10 years ago

    There is something about naming conventions for USEUNIT calls which I can't quite recall?

     

    Hang on ....

     

    Got it.

     

    https://support.smartbear.com/viewarticle/73884/#Calling

     

    (The second bullet point)

     

    If the function name and unit name are the same, the call will only work if prefixed with the unit name. Sounds like whats happening to you.

mcastellanos's avatar
mcastellanos
Occasional Contributor
10 years ago

Correction needs to be made.

 

Method 2 works; however, Method 1 does not.

  • AlexKaras's avatar
    AlexKaras
    Champion Level 3
    10 years ago

    Hi,

     

    At the first glance it should work... Could you elaborate what does 'does not work' mean? Any message/warning/error in the log? If you insert some Log.Message() call into the function1 in Unit1, is this message present in the log? What happens if you put a breakpoint in Unit2 and then Step Into ?

     

    Also, what is the actual code of Unit2?

    If you provided complete code, than I would treat the observed behavior as the expected one:

    -- script code is executed by the VBScript runtime;

    -- VBScript runtime treats 'USEUNIT clause as a regular comment and thus has no idea about Unit1;

    -- function1() in this case might be treated as an unknown function and just skipped.

    • Colin_McCrae's avatar
      Colin_McCrae
      Community Hero
      10 years ago

      There is something about naming conventions for USEUNIT calls which I can't quite recall?

       

      Hang on ....

       

      Got it.

       

      https://support.smartbear.com/viewarticle/73884/#Calling

       

      (The second bullet point)

       

      If the function name and unit name are the same, the call will only work if prefixed with the unit name. Sounds like whats happening to you.

      • mcastellanos's avatar
        mcastellanos
        Occasional Contributor
        10 years ago

        Thank you all for responding.

         

        Colin,

         

        You are right on target. That was the issue.

         

        function name was SelectRow(row) which resided in script name or unit by the same name SelectRow

        Therefore statement below was throwing an exception.

         

        SelectRow(row) 'This throws exception

        SelectRow.SelectRow(row) 'This does not throw exception

         

        I am new to TC so I am sampling the application and its potential. I realize a sound structuring of artifacts and good naming convention is as important. To this end, the case above could have been avoided by carefully naming your items.

         

        Thanks again and sorry for the trouble.

  • NisHera's avatar
    NisHera
    Valued Contributor
    10 years ago

    don't know how it's working in VB since I'm into jScripting

    But it's a great thing that method 1 not working
    imagine a case you are calling UNIT X and UNIT Y and both have function1(param1)