Forum Discussion
Xiaodong_Qin
16 years agoNew Contributor
Thank you very much for your prompt response.
I did more investigation and here are the details.
================================
Issues #2
================================
(1) I did not see anything in the "error log".
(2) I was able to reproduce the problem easily this morning
after trying a few times.
It looks like the trouble maker is the "From" tab for xml request.
I pasted an xml content to the "Request" tab, I did not use
"From" tab to import any xml file, thus this tab is empty.
Then I clicked "From" tab and went back to the
"Request" tab, the xml content pasted in the "Request" tab
was gone.
This is definitely a very strange behavior. I would assume
it can be easily reproduced in your test environment as well.
===========================
Issue #2
===========================
I am not sure what happened, if I edited a few test steps, ran a few test cases, sometimes the "Source Step" became empty, causing the test failure.
It is less severe than issue #2, but definitely very annoying.
Those 2 issues are the major reasons that prevent us from
purchasing the licenses. Since the SoapUI 2.5.1 has just been
released, I am wondering how well it is adopted in the community now.
Thanks again for your quick response!
Xiaodong
I did more investigation and here are the details.
================================
Issues #2
================================
(1) I did not see anything in the "error log".
(2) I was able to reproduce the problem easily this morning
after trying a few times.
It looks like the trouble maker is the "From" tab for xml request.
I pasted an xml content to the "Request" tab, I did not use
"From" tab to import any xml file, thus this tab is empty.
Then I clicked "From" tab and went back to the
"Request" tab, the xml content pasted in the "Request" tab
was gone.
This is definitely a very strange behavior. I would assume
it can be easily reproduced in your test environment as well.
===========================
Issue #2
===========================
I am not sure what happened, if I edited a few test steps, ran a few test cases, sometimes the "Source Step" became empty, causing the test failure.
It is less severe than issue #2, but definitely very annoying.
Those 2 issues are the major reasons that prevent us from
purchasing the licenses. Since the SoapUI 2.5.1 has just been
released, I am wondering how well it is adopted in the community now.
Thanks again for your quick response!
Xiaodong
Related Content
Recent Discussions
- 2 days agogroovyguy