In TestCase / Tab "Execution"
In Report "Test execution results (detailed)"
How/where can I manupulate this value? I want to switch to "Automated execution" for some TestCases.
You make some good points. If you would like to suggest enhancements to the product team you can do that at in the Roadmap portal: Under consideration - Zephyr Scale | Product Roadmap (productboard.com)
Is there any answer by now?
I don't remember seeing this anywhere as something that can be configured so I can only hazard a guess that it's a value set by the system depending on the method of execution, e.g. a person executes a test using the Test Player (Manual), or a test execution is posted via the API (Automated).
For a definitive answer you could try contacting SmartBear support here: SmartBear Support
Thank you for your answer. I'm afraid, it is as you say.
I had hoped that there would be a way to manipulate this manually by now. Many of the test machines can't be run in a network. The data is entered manually into Zephyr Scale, but was collected automatically. The "manual" specification in the tests is therefore simply wrong and cannot be corrected manually. This is not so tragic because the excel sheet is only a backup document.
What is SIGNIFICANTLY worse is that customised fields, which contain really essential information, are not shown in the PDF reports, in which the screenshots are also visible next to the test steps (some information you do not have in the excel sheet.) So there is NO test protocol that contains ALL data... This is indeed a problem.
