Forum Discussion
richie
Community Hero
Hey williepadin,
I cant help with this issue per se, but i have a possible suggestion.
You state you cant use Hermes on MAC, cos Hermes needs java 6 and EMS needs java7, right?
I had a similar issue a couple of years ago where some jdbc .jar drivers i needed used java2, but ReadyAPI! groovy needed java6 or 7. I thought i was stuffed. My groovy worked on java7, but soon as i downgraded my java to 2 to get the db connection sorted, i was getting runtime errors in my groovy.
I thought about it for a bit and started wondering. Yes my .jar files used java libraries from java2, but unless those libraries had been deprecated in later versions, i could in fact use later versions of java. It worked. Despite the .jar file instructions indicating java2 was needed, i could infact get my db connection and groovy working in java7.
Perhaps the same is possible for Hermes.....? Have you tried it with jdk v1.7?
Just a suggestion!
Nice one,
Rich
I cant help with this issue per se, but i have a possible suggestion.
You state you cant use Hermes on MAC, cos Hermes needs java 6 and EMS needs java7, right?
I had a similar issue a couple of years ago where some jdbc .jar drivers i needed used java2, but ReadyAPI! groovy needed java6 or 7. I thought i was stuffed. My groovy worked on java7, but soon as i downgraded my java to 2 to get the db connection sorted, i was getting runtime errors in my groovy.
I thought about it for a bit and started wondering. Yes my .jar files used java libraries from java2, but unless those libraries had been deprecated in later versions, i could in fact use later versions of java. It worked. Despite the .jar file instructions indicating java2 was needed, i could infact get my db connection and groovy working in java7.
Perhaps the same is possible for Hermes.....? Have you tried it with jdk v1.7?
Just a suggestion!
Nice one,
Rich
williepadin
4 years agoOccasional Contributor
Yes I did. HermesJMS does not start correctly with 1.7.
Thank you for your suggestion though!
Willie
- richie4 years agoCommunity HeroHey williepadin,
Thats me for suggestions then. I did have a quick look and TIBCO have produced a .pdf indicating how to configure an EMS connection with soapui, but the .pdf doesnt mention the operating system at all (so assumes Windows, not MAC), references eviware not smartbear (so its quite old) and suggest using Hermes.
I got nothing else. I should highlight that i found that after a minute of searching. Have you done an relatively exhaustive search? There may be posts on other forums such as stackoverflow, etc.
Ta
Rich- williepadin4 years agoOccasional Contributor
Rich,
This has not been solved by any suggestions. Once it is I will provide the solution here. There is no problem in windows at all but I need it working on mac.
Thanks!
Willie
Related Content
- 4 years agogoto8