There is.
ScrollIntoView is an available method on most controls.
But as you are running on a VM, it would be FAR easier to simply configure that to run at a higher (virtual) resolution. It's a VM, so you can control the configuration.
After activating the picture capture while running i found the source of this issue. It is the resolution. The controls i want to perform an action onto are not visible and therefore the test always fails.
Is there a way to set a control to visible or force TC to scroll itself till the object is visible/accessible (the object exists and is found by TC)?
There is.
ScrollIntoView is an available method on most controls.
But as you are running on a VM, it would be FAR easier to simply configure that to run at a higher (virtual) resolution. It's a VM, so you can control the configuration.
Hi,
i solved the problem with setting the resolution at the beginning of each test to 1920x1080. i used the following sample to do the setting --> https://support.smartbear.com/viewarticle/8962/
Thanks for the hint.
