Forum Discussion

RaresB's avatar
RaresB
Occasional Contributor
10 years ago

Test Execute runs tests at screen resolution or less than 800x600 on a slave machine

Hi, I'm running tests from TestExecute on a slave machine with Jenkins. The problem is that the screen is displayed at resolution or less than 800x600 and the some objects from the browser are not ...
  • Colin_McCrae's avatar
    Colin_McCrae
    10 years ago

    I don't know Jenkins, but I tend to agree with Alex in that the screen resolution of the slave (assuming it's virtual?) machine should be something you can configure.

     

    When running on a VM with TestExecute I make sure the VM is configured with a 1920x1080 display to match the development environment ....

RaresB's avatar
RaresB
Occasional Contributor

Hi Alex,

 

Thanks for the suggestion, we already use the ScrollIntoView() method to scroll upside/down on the local machines where we have the screen at full size.

 

Due to the small resize of the screen on the slave machine the problem persists because a scroll from right to left and viceversa is also needed for objects to became visible.

joseph_michaud's avatar
joseph_michaud
Moderator
10 years ago

In the Advanced section of the Jenkins "TestComplete Test" build step, what is your selection for "Run interactive user session" and the User and "Use active session" values in that section?

 

What size screen do you get when you log in to the slave manually as that specified user?

  • Colin_McCrae's avatar
    Colin_McCrae
    Community Hero
    10 years ago

    I don't know Jenkins, but I tend to agree with Alex in that the screen resolution of the slave (assuming it's virtual?) machine should be something you can configure.

     

    When running on a VM with TestExecute I make sure the VM is configured with a 1920x1080 display to match the development environment ....

    • tonydugay's avatar
      tonydugay
      Contributor
      10 years ago

      I have a problem (maybe it is the same) that if I send the RDP session to the console using tscon (so I can close my RDP session without breaking the tests) the screen resolution is much reduced and breaks some tests.  I have seen various possible workarounds for this but I have never got round to getting them to work.  One solution is to use VNC and you can then make a one off change to the console screen resolution setting.  Another is to use an application called Qres. 

       

      Any 'easy' solutions would be great to hear about.

       

      Cheers,

      Tony