Forum Discussion

dhundley's avatar
dhundley
Regular Contributor
3 years ago

starting (not installing) testexecute in azure pipeline

ok. so, i have a VM that has testexecute already installed (but not running) and we have the id based licensing. i have an azure pipeline that has the "testcomplete test adapter installer" step in it...
  • dhundley's avatar
    dhundley
    3 years ago

    after some further testing i think i did finally figure it out. i tool a closer look at the error message i was getting

    and decided i would try regenerating my access key and plugging the new one into the test adapter installer step. with the new key in place and just the "install" runner checkbox checked it successfully started testexecute, ran my test and stopped testexecute when the test finished. 

     

    thanks!

  • dhundley's avatar
    dhundley
    Regular Contributor
    3 years ago

    i have gone through all those links before i posted this in the forum. none of them (at least as far as i can tell) explain how i can configure my pipeline so that it "starts" testexecute on the agent VM as the test is ready to begin and "exit" out of testexecute when the test has completed (like it works with the NetworkSuite). the only things that even seem close are the two options for install runner and update runner and i've tested with those checked and unchecked and neither way works. my pipeline works just fine if testexecute is left running all the time and those boxes are unchecked EXCEPT when we sometimes cancel a pipeline and then (for some reason) testexecute hangs up (all context menu options are gray/disabled) until it gets bounced. if the test adapter step could be configured to start and stop testexecute (like the networksuite is able to do) that would resolve the issue since it would always be a fresh run of testexecute each time. 

     

    rather than just pointing me to a webpage full of links, please either tell me how it can be done or tell me its not possible to do in azure devops. 

    • Marsha_R's avatar
      Marsha_R
      Moderator
      3 years ago

      I help where I can. Some users are happy to have the links. If they're not helpful, it's easy for you to just ignore them.  Good luck with Azure!   

      • dhundley's avatar
        dhundley
        Regular Contributor
        3 years ago

        after some further testing i think i did finally figure it out. i tool a closer look at the error message i was getting

        and decided i would try regenerating my access key and plugging the new one into the test adapter installer step. with the new key in place and just the "install" runner checkbox checked it successfully started testexecute, ran my test and stopped testexecute when the test finished. 

         

        thanks!