Forum Discussion

beginTC's avatar
beginTC
Occasional Contributor
2 years ago
Solved

QAComplete cannot terminate TestExecute

I am currently using QAComplete in cloud to run tests on TestExecute in local. The QAComplete can run the test properly, but somehow it cannot close the TestExecute when I am using certain software. ...
  • beginTC's avatar
    beginTC
    2 years ago

    This issue happened some time ago, then got recovered. Then it happened last week and now it got recovered again. I know that there are some company refresh change made to the computers, but not sure what may have caused the issue. For now this problem has not been observed, but chances are that it could happen again next time.

beginTC's avatar
beginTC
Occasional Contributor
2 years ago

I created a batch file to terminate the TestExecute to be initiated after my test is done. The batch could terminate the TestExecute, then QAComplete could receive the log. The issue is that the QAComplete will display all to be "Passed" even when the test is failed... 

I think the termination using command line will somehow send back the exit code or whatever code to QAComplete to indicate the result. Since the termination command is passed, the QAComplete will always display as passed...

  • JDR2500's avatar
    JDR2500
    Frequent Contributor
    2 years ago

    What about killing the process before you start your tests running rather than at the end?  We do something like that to make sure our application isn't running when we try to install/uninstall it.  Jenkins runs the PS script before launching the TestComplete project.

    • beginTC's avatar
      beginTC
      Occasional Contributor
      2 years ago

      I mean I could do that. But starting the test is always fine for me. It is about stopping the test. We are using QAComplete to control the TestExecute to test in local computer, but the QAComplete cannot stop the TestExecute.