Forum Discussion
4 Replies
- AlexKarasChampion Level 3
Hi,
Just to double check:
cmdObj.Parameters.Append(prm4);
prm1.size=10;
prm4.Value=mc_id;Is it a typo to reference prm1 instead of prm4 or not?
- Marsha_RModerator
This TestComplete forum probably isn't the best place for db2 support. Did you try finding a db2 forum?
- hbOccasional Contributor
The issue is only happening when i invoke it from Test complete, it is doesnot occur when i invoke that stored procedure direclty from the DB itself or our applicaiton.
- Marsha_RModerator
Okay, that's important. Without complete details of your test, it's difficult to guess what might be going on.
If I was troubleshooting this, I would take the "numeric value out of range" and work with that. If you are calculating this value, then try hardcoding it instead and use the value that you think it sending through, for instance, if the calculated value should be 10000, hard code that instead and see if it works. The calculation may not be working the way you think it is.
If the value is stored in a variable, make sure that the variable is of the proper type to give you the answer you expect.
Related Content
- 12 years ago
- 10 years ago
- 12 years ago
- 5 years ago
Recent Discussions
- 2 days ago