Forum Discussion
Hi,
Assuming that you are using the latest version of AQtime (8.60 at the moment of writing), I would recommend to check this thread: https://community.smartbear.com/t5/AQtime/Do-not-see-fake-memory-leak-in-a-DLL/td-p/128574.
Does it help ?
- quinn8 years agoNew Contributor
Thanks for the link. Yes, that is the version of AQTime I am using. I checked out those posts but didn't get any information about anything I haven't already tried. At this point, what I've noticed is that I can get results when I have my .exe and two of my DLL's included in the project setup pane. But other DLL's that are used by my application and I would like to profile seem to cause a problem with AQTime. When I add them to the project and run it, everything seems to run normally but when the application exits there are no results in the Last Results pane.
- AlexKaras8 years agoChampion Level 3
Hi,
Any chance to provide here a (sample) application that demonstrates the problem you are talking about?
If not, then you may create a Support ticket via the https://support.smartbear.com/message/?prod=AQtime form and provide Support with the information that can not be posted here.
> But other DLL's that are used by my application and I would like to profile seem to cause a problem with AQTime.
Can you be more specific as for the problem description? Steps, observed behavior, screenshots, ... ?
Related Content
- 15 years ago
- 15 years ago
- 2 years ago
- 14 years ago
Recent Discussions
- 5 months ago
- 2 years ago