ContributionsMost RecentMost LikesSolutionsRe: Bug: : Resource from resource path is getting cleared yes PrathapR thats true. This defect was in 3.53.0 version as well. I have already raised the support ticket before writing here. Its a good community space here to write such issues. So, that other Ready API users are also aware of such defects. Bug: : Resource from resource path is getting cleared Hi all, I have found one bug in new Ready API version 3.54.0: Resource from resource path is getting cleared with below steps: 1) Configure and send a API request. 2) Move the cursor to resource. 3) Now again try to send the request. 4) We can see resource is now empty/cleared. Re: ReadyAPI: New requirement to run 1M request in 30 minuntes Thank you. I know its very important points. I have already taken care of it 😊 Re: ReadyAPI: New requirement to run 1M request in 30 minuntes Thank you KarelHusa for your response. Its the test requirement from the project. And if you say "virtually it is possible to process 1 M requests with 250 VUs in 30 minutes". How should I configure this. I mean which type of load allocation I should selct (Relative, Equal, Per Scenario) and what be the values inside it. ReadyAPI: New requirement to run 1M request in 30 minuntes Hi Team, We have an requiremnt to run 1M request in 30 minuntes. And I have Load UI licence too which allows maximum 250 VU's. I want the configuration settings in Load Ui to run 1M request in 30 minuntes. SolvedRe: -pPassword is not working when I try to decrypt the project using Jenkins windows batch cmd-ReadyAPI I was using worng argument -p, it has worked with -xABCD (Eg. ABCD is password) -pPassword is not working when I try to decrypt the project using Jenkins windows batch cmd-ReadyAPI -pPassword is not working when I try to decrypt the project using Jenkins windows batch cmd (ReadyAPI). However I am passing correct password. When I try to open the decrypted project in ReadyAPI manually, it opens successfully with correct password. I dont know why it is not working from Jenkins command line. Solved