Parameters are greyed out

[tobenschain]

Why are my AQtime|Parameters menu command greyed out?

[AlexKaras]

Hi,

Assuming that you have project created and profiled application been specified, what profiling mode has been set?

As per https://support.smartbear.com/viewarticle/43083/ : "You can specify run parameters for all profiling modes, except for the Service mode."

The more information (including screenshots) you provide about your problem, the higher chances to get a helpful piece of advice.

[tobenschain]

The AQtime parameters are disabled again in Delphi XE7. What causes it? I will need to set them. I am using the Allocation Profiler.

Thanks

Tom

[tobenschain]

here is a screen capture:

[AlexKaras]

Hi,

Same question: what profiling mode (not profiler, but profiling mode) is set?

https://support.smartbear.com/viewarticle/43009/ (last paragraph) mentions how to check/set it in Delphi.

Also https://support.smartbear.com/viewarticle/43083/ might help.

[tobenschain]

the buttons are greyed out. see attached

[AlexKaras]

Hm-m... No ideas at the moment, sorry.

Try to contact Support via the https://support.smartbear.com/message/?prod=AQtime form, reference this thread and see what the reply will be.

[tobenschain]

thanks, i just needed to open the aqtime profiler in project manager

[AlexKaras]

Hi,

Thank you for the update.

All this thread is for AQtime Pro, not the version shipped with Delphi, right ?

[tobenschain]

<<All this thread is for AQtime Pro, not the version shipped with Delphi, right?>>

yes