Parameters are greyed out
Why are my AQtime|Parameters menu command greyed out?
Forum Discussion
Hi,
Assuming that you have project created and profiled application been specified, what profiling mode has been set?
As per https://support.smartbear.com/viewarticle/43083/ : "You can specify run parameters for all profiling modes, except for the Service mode."
The more information (including screenshots) you provide about your problem, the higher chances to get a helpful piece of advice.
The AQtime parameters are disabled again in Delphi XE7. What causes it? I will need to set them. I am using the Allocation Profiler.
Thanks
Tom
here is a screen capture:
Hi,
Same question: what profiling mode (not profiler, but profiling mode) is set?
https://support.smartbear.com/viewarticle/43009/ (last paragraph) mentions how to check/set it in Delphi.
Also https://support.smartbear.com/viewarticle/43083/ might help.
