Forum Discussion

maumrm's avatar
maumrm
Contributor
2 years ago
Solved

The specified browser was not found. [Current Browser]

I am getting failures for Navigating to an address based on the "Current Browser". These steps do not fail during a full test run, but if I start the test midway these will fail, not sure why they wo...
Marsha_R's avatar
Marsha_R
Champion Level 3
2 years ago

Without seeing the code, it's hard to tell. There's something that's being executed that allows this to work that you are skipping when you run the test midway. For troubleshooting, I suggest starting the midway test a few steps earlier than you are doing now and see if that works. If not, back up a few steps more and keep doing that until it works. That will help you narrow down the needed commands.

  • maumrm's avatar
    maumrm
    Contributor
    2 years ago

    So this is the start of the test, if I stop the test at the Navigate step, then start from the "textboxUsername" step the Navigate steps fails. It would seem to be something to do with the "Browser Loop" step. If it starts from there everything works, but that doesn't allow me to start from the middle, or any point beyond the beginning. 

     

    Is there some property that Test Complete is keeping for what is the "Current Browser" because of the "Browser Loop" that is lost if the test is not starting from that point? Almost like before each Navigate step I need something to tell what the "Current Browser" is, since that could be Chrome, Edge, etc, but is not called "Current Browser". 

      • maumrm's avatar
        maumrm
        Contributor
        2 years ago

        Ok, thank you. That is a little cumbersome but if that is what is needed then that I what I'll do. Thank you.