Forum Discussion

DavidE's avatar
DavidE
Contributor
7 years ago

TestComplete 12.50 and Windows 10 (1709)

We are having a problem with tests in Windows 10 that were developed on the same system as the ones we are currently executing the tests on where the test will end prematurely with only a message tha...
  • DavidE's avatar
    DavidE
    7 years ago

    shankar_r I appreciate the willingness to try and help, but I did just discover the problem.  We use Jenkins to execute our tests, and we had set some timeout values for the test, i.e. a maximum run time.  Due to some changes in our environment some of these tests are running longer than they used to and as a result are hitting the timeout values and Jenkins is stopping the test.  So it is truly being interrupted.

     

     

shankar_r's avatar
shankar_r
Community Hero

DavidE, "The test execution was interrupted." It usually comes when you stop the test manually. 

This will happen when you enabled StopOnError.

 

Do you have StopOnError enabled in your project?

DavidE's avatar
DavidE
Contributor
7 years ago

Most all our tests run with Stop on Error enabled shankar_r.  However, I took your suggestion and turned it off.  The test did run to completion.

 

However, that brings me to my next question.  What error am I getting?  As I said, the commands are being executed successfully up until the point where I get the test interrupted message.  There is no prior error and nothing else is stopping the test.

  • shankar_r's avatar
    shankar_r
    Community Hero
    7 years ago

    What you see in the Additional Information tab of that error message?

    • DavidE's avatar
      DavidE
      Contributor
      7 years ago

      I get the following message.  However, there are no other errors in the log, I did not stop the test manually, and my test does not call the Runner.Halt method.

       

      Possible reasons:
      - An error or warning occurred during the test run. See the preceding log entries to locate and identify the error.
      - The test run was stopped manually.
      - The test run was terminated as a result of the Runner.Halt method call.

      • shankar_r's avatar
        shankar_r
        Community Hero
        7 years ago

        It does not give me any clue, Can you post a screenshot of the log message?