Forum Discussion

smartbutton's avatar
smartbutton
Occasional Contributor
10 years ago

Getting browser already open error message in Test Execute

Hi,   I am trying to run a project in Test Execute, first script is running successfully and closing the browser at the end of the script. For running the second script Test execute is stopping an...
DCat1223's avatar
DCat1223
Frequent Contributor
10 years ago

Hi Anna...

 

I was having the same issue.  I resolved this by putting a 15000 MS (15 second) delay in at the end of the script to give the browser time to fully close.  I'm using the Keyword test, not scripted.  This is in the Miscellaneous tab of the Operations pannel.

 

Hope this helps you out.

 

Dave.

smartbutton's avatar
smartbutton
Occasional Contributor
10 years ago

Hi Dave,

 

I tried  putting 15 seconds wait time at the end of each script after closing the browser and running them in TE but getting the same error.

 

Thanks,

Anna

    • smartbutton's avatar
      smartbutton
      Occasional Contributor
      10 years ago

      Thank you Dave for your input, putting Tesrminate method on Browser did the trick for me.

      • DCat1223's avatar
        DCat1223
        Frequent Contributor
        10 years ago

        Great!  Glad you found a solution!