Forum Discussion

Emanuela's avatar
Emanuela
New Contributor
5 years ago

ClickCell() action returns "an error occured" while clicking on QTableWidget.

Hello everyone,   we are testing a desktop application, built with Qt libraries and we stumbled in an issue when testing it with TestComplete (v14.60)   Attached are few screens of what is the si...
clickcell
Qt
QTableWidget
  • Emanuela's avatar
    Emanuela
    5 years ago

    We have found a solution.

    For a correct execution of the test it is necessary to do:

    First the Click() method on the qt_scrollarea_viewport to focus the table and  after the ClickCell() method to target row.

     

    Thank you so much to everyone.

     

     

Marsha_R's avatar
Marsha_R
Moderator
5 years ago

If you record a test and do the same steps manually, do you still see the error?

  • Emanuela's avatar
    Emanuela
    New Contributor
    5 years ago
    Yes. I tried to use a selectRow() method and with it the problem doesn't occur but I need to a click action.
     
    • Marsha_R's avatar
      Marsha_R
      Moderator
      5 years ago

      So you recorded a test and it gave you a selectRow and that works if you run that recorded test again?

       

      If that's true, then why not put a selectRow in your test before the click that you need?  Perhaps that will give the correct focus on the object.

      • Emanuela's avatar
        Emanuela
        New Contributor
        5 years ago

        even with the selection + click sequence the error occurs.