Forum Discussion

pablofuentesbod's avatar
pablofuentesbod
Occasional Contributor
8 years ago

Transfer property value to request header in next step.

Hi all,   I'm trying to transfer one property from one test step response to next step request.   I have managed to extract the property in a property called myproperty but now I need to use this...
  • nmrao's avatar
    nmrao
    8 years ago

    Hmm, really frustrating for both.

     

    Step1:

     

    Select test case name, and select custom tab and add property as mentioned and leave value blank (a Property Transfer step is going to write value for this )

     

    Step 2 : Go to Property transfer step, make the changes as suggested in the image i.e., Select the test case for the target drop down and Select the Property name

     

     

    Then remove the tem_property test step

     

    Step 3:

     

     

     

     

pablofuentesbod's avatar
pablofuentesbod
Occasional Contributor

Hi rao,

 

thanks for the update.

 

I have never used scripts in soap iu .. planning to do using gui as relly straight forward but it in my case it does not work ... the authetification header is not replaced with the property value.

 

I'm trying to set the authetification header with the vakue if the property / response tag.

 

thanks for your help.

 

best regards, Pablo.

 

nmrao's avatar
nmrao
Champion Level 3
8 years ago
Hmm.. there seem to be otherway without script too.

Transfer the property to test case level, say DYNAMIC_AUTH as property name and store the value.

In the next request, add header with required header name and value as ${#TestCase#DYNAMIC_AUTH}

Hope the above should help.
  • pablofuentesbod's avatar
    pablofuentesbod
    Occasional Contributor
    8 years ago

    Hi Rao,

    thanks so much for your help and support, really appreciated.

    I have tried with the following value:

    ${#LoginStep#myproperty}

    at authetification headers and the value is empty.

    attached the config done and the test results where you can see that myproerty is correctly assigned but the auht header value no :-(.

    any idea ???

    best regards, Pablo.

     

     

     

     

    • nmrao's avatar
      nmrao
      Champion Level 3
      8 years ago
      You seemed to replace some value and created an addition properties step and both are not suggested. Just follow the previous reply as it is, no change ( or replace any values for test case)
      • pablofuentesbod's avatar
        pablofuentesbod
        Occasional Contributor
        8 years ago

        Hi rao,

         

        thanks for your help.

         

        I have only created a tranfer step and and a property to store the value, this seems to work fine.

         

        On the other side only assiged the value as suggested (${#LoginStep#myproperty}).

         

        Sorry bu I can not see extra steps in my project.

         

        can you help me ??

         

        best regards, pablo.