Forum Discussion

jtslimited's avatar
jtslimited
New Contributor
4 years ago

The signature or decryption was invalid

Hi All! When I issue a request using SoapUI 3.5 I get a successful response. When I attempt the same request using SoapUI 5.6, I get a failure response, <faultcode>wsse:FailedCheck</faultcode> <faul...
  • jtslimited's avatar
    jtslimited
    4 years ago

    Okay. I have a bead on the issue. I was reviewing with a colleague today that observed through Fiddler that the content-length was not consistent with the request body length. the difference in content-length reflected the number of lines in the message. On a whim, we used Notepad++ to convert all newline characters to end of line characters and voila! Success!!! Somewhere between Fiddler and our text editor, the end of line characters were being converted to newline characters. 

richie's avatar
richie
Community Hero

Hey jtslimited 

 

I'd use Fiddler to try and identify the issue.

 

Fiddler can be used as a proxy - you pass the requests to your endpoint via Fiddler and it scrapes the detail from the request.

 

So I'd setup SoapUI v3.5 with Fiddler as a proxy and submit the request - export the request details for later comparison

Then I'd setup SoapUI v5.6 with Fiddler as a proxy and submit the request 

Compare the details - this should indicate the differences between the requests helping you to diagnose the issue.

 

ta

 

rich

jtslimited's avatar
jtslimited
New Contributor
4 years ago

Hey Rich! Thanks for the suggestion. I'm having trouble with SoapUI 5.6 trusting Fiddler as a proxy. So I pivoted to a simple .net application that posts the request I've copied out of SoapUI 3.5. The Fiddler traces for raw request body between SoapUI 3.5 and my utility are a match. I'll continue to investigate. 

  • jtslimited's avatar
    jtslimited
    New Contributor
    4 years ago

    Okay. I have a bead on the issue. I was reviewing with a colleague today that observed through Fiddler that the content-length was not consistent with the request body length. the difference in content-length reflected the number of lines in the message. On a whim, we used Notepad++ to convert all newline characters to end of line characters and voila! Success!!! Somewhere between Fiddler and our text editor, the end of line characters were being converted to newline characters.