SSL enabled mock service
Hello, I am trying to create a mock service and then send request messages to this mock service from within SoapUI. When these request messages are send over http everything works well, but when I ...
Forum Discussion
hi
this appears to be a common issue across this forum with no answer (that i could locate either here or elsewhere on the web). i was about to start a new thread but instaed thought it best to add to this one.
in simple terms how does one run soapui mock web services under ssl??? what are the steps?? a doc pointer with this info would be great.
i have entered the following under ssl preferences:
keyStore
keyStore password
set to Enable Mock SSL
Mock Port
Mock KeyStore
Mock Password
Mock Key Password
so what now? i have created my mock service. where do i tell that service that it will be running under ssl? how is it configured
?? it runs fine under http... but not so https.
i really think this is something lacking in the docs right now and the responses to similar very simple and direct questions have been rather unhelpful.
suggestions would be greatly apprecitaed
thanks heaps
Tim
this appears to be a common issue across this forum with no answer (that i could locate either here or elsewhere on the web). i was about to start a new thread but instaed thought it best to add to this one.
in simple terms how does one run soapui mock web services under ssl??? what are the steps?? a doc pointer with this info would be great.
i have entered the following under ssl preferences:
keyStore
keyStore password
set to Enable Mock SSL
Mock Port
Mock KeyStore
Mock Password
Mock Key Password
so what now? i have created my mock service. where do i tell that service that it will be running under ssl? how is it configured
?? it runs fine under http... but not so https.i really think this is something lacking in the docs right now and the responses to similar very simple and direct questions have been rather unhelpful.
suggestions would be greatly apprecitaed
thanks heaps
Tim
