Forum Discussion
Hi,
I meant to try Threads=1, runs per thread=10 (for example, or bigger), do you get a count of 10 in this case? I am asking as a sanity check, in other words this should result in each TestStep in the TestCase being run 10 times. Then, if this works, increase the number of threads until you notice the counts become inconsistent - this might indicate a thread contention issue.
I would say that, to simulate multiple users (threads) hitting your endpoint, that your load test is correctly setup, so like you say "Or should it be as I have it now, which is: three separate teststeps, in 1 test case with 1 loadtest testing all three 'at the same time'?"
Regards,
Rup
rupert,
Thank you. Upon inspection, I still had quite a lot of debug enabled on the server side hosting the service. Since turning it off, the tests are executing as expected.
I do have another thread/question open about runloadtester.sh and the output it throws to the screen. If you have any experience with the command line execution, I could really use your expertise.
Thank you for all your help & feedback.
~Matt
- rupert_anderson9 years agoValued Contributor
Hi Matt,
No problem, happy to have helped :-)
OK, will take a look at the other thread.
Regards,
Rup