Forum Discussion

adam10973's avatar
adam10973
New Contributor
9 years ago

Make testrunner run all test steps despite failure?

Is it possible to make testrunnter.bat run all test steps in a test case even if one fails? Currently, it's stopping after a failure. I've tried option -I with no luck.
  • Radford's avatar
    Radford
    9 years ago

    Have you investigated the TestCase options? In particular the two options:

     

    • Abort on Error
    • Fail Test Case on Error

    You may find adjusting these two will suit your needs.

     

    Note: You can also set defaults for these settings in the main preferences, but from reading the documentation, this is just the defaults for newly created test cases, it will not update pre-existing test cases.

     

     

Radford's avatar
Radford
Super Contributor

Have you investigated the TestCase options? In particular the two options:

 

  • Abort on Error
  • Fail Test Case on Error

You may find adjusting these two will suit your needs.

 

Note: You can also set defaults for these settings in the main preferences, but from reading the documentation, this is just the defaults for newly created test cases, it will not update pre-existing test cases.

 

 

ddineesh's avatar
ddineesh
New Contributor
6 years ago

This solution works fine for me. Thanks.