Table output doesn't display all rows
I have a load test and numerous table outputs attached. I have it set up to save the files to .csv in the .loadui directory. The trouble is that the files don't always contain the results rows they s...
Forum Discussion
SmartBear_Suppo
Alumni
AlumniHi,
Sorry for the late response.
What do you have in "Max Rows in Table" file in General tab
of table log settings dialog? Is it 1000?
I was able to reproduce this, and I'm getting good results when
total number of rows is lesser than 1000 but when is greater
results are unpredictable. So, I suspect this setting is making
trouble. Please, try to put greater number there (>24000) and see
if it is working as expected. If we confirm this I will open an ticket.
Note that in general not all component outputs will generate messages for
each input request. Some will output one message per second so in the end
you will have around 180 lines (3 minute test) and that's fine.
regards!
Predrag
SmartBear Software
Sorry for the late response.
What do you have in "Max Rows in Table" file in General tab
of table log settings dialog? Is it 1000?
I was able to reproduce this, and I'm getting good results when
total number of rows is lesser than 1000 but when is greater
results are unpredictable. So, I suspect this setting is making
trouble. Please, try to put greater number there (>24000) and see
if it is working as expected. If we confirm this I will open an ticket.
Note that in general not all component outputs will generate messages for
each input request. Some will output one message per second so in the end
you will have around 180 lines (3 minute test) and that's fine.
regards!
Predrag
SmartBear Software