Forum Discussion

Marc_Ludwig's avatar
Marc_Ludwig
Occasional Contributor
16 years ago

Outgoing WSS settings lost

Hi
All our Web Services require WS-S headers being sent.
I have used the WS-Security Configurations at the project level to set up an outgoing configuration (referencing some global properties).
I am able to select this as an "Outgoing WSS" within the Interface settings, but it appears to be lost when saving the project.

Is this the correct way of adding WS-S header to all outgoing messages, or is there an alternative to make sure that all tests (load balancing, integration tests etc.) always include this.

Manyy Thanks
Marc

6 Replies

Sort By
  • omatzura's avatar
    omatzura
    Super Contributor
    16 years ago
    Hi Marc,

    If you set the "outgoing wss" for the desired endpoint in the Interfaces "Service Endpoints" tab, this should add the configured headers to all messages to that endpoint (ie you are doing it right!).. I'll have to check on the saving issue.. are you using the 2.5 beta or a previous version?

    regards!

    /Ole
    eviware.com
  • Marc_Ludwig's avatar
    Marc_Ludwig
    Occasional Contributor
    16 years ago
    Thanks for the reply.
    We're using the production version 2.0.2.
    It does add the WS-S info to each of the endpoint messages, but does look to lose the setting between saves.

    Marc
  • omatzura's avatar
    omatzura
    Super Contributor
    16 years ago
    Hi Marc,

    I can confirm that this is a bug in the current version and will be fixed in the upcoming 2.5 beta2 release.. thanks for your feedback!

    /Ole
    eviware.com
  • Marc_Ludwig's avatar
    Marc_Ludwig
    Occasional Contributor
    16 years ago
    Thanks for confirming this Ole.

    Can you advise when the 2.5 release is scheduled for production?

    Marc