Cannot run test case and no UI show
Hi, I can run a project that using soapUI runner, load generator (fixed rate) and table log. But when all the things put inside a test case level, nothing run. also no response after pressing the...
Forum Discussion
SmartBear_Suppo
Alumni
AlumniHi!
hmm... instead of specifying the keystore at the global level in soapUI, I wonder if you could try the following;
1) Open the Project window for your soapUI project
2) Go to the Security Settings tab and add your keystore here as a certificate
3) Go to the request(s) requiring the keystore and select the added certificate for the "keystore" setting in the bottom left list of properties for each TestStep
4) Make sure your TestCase works in soapUI
5) Save your project and try running the TestCase in loadUI
Does that work any better?
regards!
/Ole
eviware.com
hmm... instead of specifying the keystore at the global level in soapUI, I wonder if you could try the following;
1) Open the Project window for your soapUI project
2) Go to the Security Settings tab and add your keystore here as a certificate
3) Go to the request(s) requiring the keystore and select the added certificate for the "keystore" setting in the bottom left list of properties for each TestStep
4) Make sure your TestCase works in soapUI
5) Save your project and try running the TestCase in loadUI
Does that work any better?
regards!
/Ole
eviware.com