Cannot run test case and no UI show
Hi, I can run a project that using soapUI runner, load generator (fixed rate) and table log. But when all the things put inside a test case level, nothing run. also no response after pressing the...
Forum Discussion
Thanks for the reply.
I can run the test case now! but most of the test steps are returned false in table log. Only the step Properties run True, others like REST step are false.
Attached u may find the screen captures (systemlog.jpg and agent.jpg)
Those test steps are running successfully in SoapUI 3.6 Pro.
I wonder if the load agent setting does not correct as I am using localhost.
Way I set is
> In Workspace screen, drag out an agent
> Type https://localhost:8443 to be Agent URL (create_agent.JPG)
> (a pop up come out said "No Agent detected at specified address, add anyway?")
> Press OK
Please advise. Thanks again.
I was trying to set the whole environment up based on the steps from the link provided but unluckily still cannot success.
Or would you have other manual or tutorial that I can follow?
I can run the test case now! but most of the test steps are returned false in table log. Only the step Properties run True, others like REST step are false.
Attached u may find the screen captures (systemlog.jpg and agent.jpg)
Those test steps are running successfully in SoapUI 3.6 Pro.
I wonder if the load agent setting does not correct as I am using localhost.
Way I set is
> In Workspace screen, drag out an agent
> Type https://localhost:8443 to be Agent URL (create_agent.JPG)
> (a pop up come out said "No Agent detected at specified address, add anyway?")
> Press OK
Please advise. Thanks again.
I was trying to set the whole environment up based on the steps from the link provided but unluckily still cannot success.
Or would you have other manual or tutorial that I can follow?
