DLL Allocation profiling No Result
Good Morning, I am trying to profile memory allocation in a DLL, say pluginDLL.dll. I create a new project in AQTime and add the module 'pluginDLL.dll'. This DLL is compiled in Release x64 with...
Forum Discussion
Hi,
Just an idea: try not to attach to the process, but specify your MainApp.exe as a host application in the Run|Parameters... dialog. Then execute the Run|Run command. This should start MainApp.exe with the profiler attached to it. Open your plug-in, do whatever required in it and try to get the results.
Also, before starting profiling, check that either profiling of the entire application is enabled in the Code To Profile panel (which I am not sure you need) or create a new including area (if areas are supported by the selected profiler) and add pluginDLL.dll to it. (See AQtime help for more details about profiling areas).
If the above does not help, you may try contact Support: http://support.smartbear.com/about-troubleshooter/
Just an idea: try not to attach to the process, but specify your MainApp.exe as a host application in the Run|Parameters... dialog. Then execute the Run|Run command. This should start MainApp.exe with the profiler attached to it. Open your plug-in, do whatever required in it and try to get the results.
Also, before starting profiling, check that either profiling of the entire application is enabled in the Code To Profile panel (which I am not sure you need) or create a new including area (if areas are supported by the selected profiler) and add pluginDLL.dll to it. (See AQtime help for more details about profiling areas).
If the above does not help, you may try contact Support: http://support.smartbear.com/about-troubleshooter/
