ContributionsMost RecentMost LikesSolutionsBest practices for Mock request validation Hi, I am looking for the best practices or patterns to perform validations on the requests received to the mock service. This will help me ensure that the ESB is applying the right mapping rules. The SOAP message format exposed by ESB are different to the format of the provider in this case the SoapUI mock service. Regards, Vijay Re: For swaRef Attachments/MTOM the type shows as MIMEWhen I enable the request for MTOM and choose the CID then XOP is being displayed, I am still wondering how to get SWAREF displayed. ThanksRe: After attaching the document, it still shows Type as UNKNOWN under Attachments.The wsdl does not state the MIME Parts. All the wsdl parts which are attachments should be stated as MIME parts so that the same are sent as MIME parts rather than literal. I think the type definition and binding should be modified as below Types Definition--- Method binding--- For swaRef Attachments/MTOM the type shows as MIMEHi, I am trying to work with SOAP attachments, in the wsdl though I specify the type as ref:swaRef or xmime:base64Binary in the soapUI's attachments tab the type still shows as MIME I think it should display SWAREF or XOP. I am attaching the wsdl and the soapUI (v 3.5 beta2) screenshot. Thanks, VijaySOAP Monitor not capturing packetsHi, I had a simple HelloWorld web service running on WebSphere7.0. I was able to send request and receive reply from SOAPUI but when I start the SOAP Monitor for the project which has just one WSDL, no data is being displayed in the SOAP monitor when message being exchanged by SOAPUI. I am enclosing the WSDL that has been loaded into SOAPUI for sending messages and SOAP monitoring. Any direction in this regard would be much appreciated. Regards, Vijay