Contributions
Re: REST POST Body project file not saving 02/03/04/05/06 ASCII control codes
So, reviewing I see two different issues in supporting control codes (unless there is a workaround...just surprised it works in the tool before save, but doesn't after save/reload). XML versions 1.1 would be needed for the special characters. -- This loads fine with the current 5.2.1 tool as XML 1.1, but gets overwritten on save. Need to encode them along the lines of for GS /29 characters for example. -- This does not load fine with current 5.2.1 tool.1.1KViews0likes0CommentsRe: REST POST Body project file not saving 02/03/04/05/06 ASCII control codes
Again, these are ascii control codese ISA00 or for visual, ISA[GS]00[GS] where [GS] is \29 group separator. Using notepad++ would show ascii control codes in associated files. I've attached a text file that contains the control codes as an example. http://www.theasciicode.com.ar/ascii-control-characters/group-separator-ascii-code-29.html However, the .xml project file save/load, it comes back as: ISA?00? no more control codes.1.1KViews0likes1CommentREST POST Body project file not saving 02/03/04/05/06 ASCII control codes
Hi All, I'm using the REST POST feature, and in the body I'm putting in ASCII control codes (i.e. STX/ETX 02/03, and others). When I put them into the body and hit 'play' and run the tests, works great. However, after save and reload, it replaces the control codes with '?' and the same 'play' no longer works. Copy/paste replace with a payload with the control codes back to working fine. Save/reload, back to '?'. How to have the 'save' and reload work with control codes? thanks! -D1.1KViews0likes3CommentsWay to test http parameter based response service
Trying to be careful with my terminology, as not sure if this is 'REST' or not. Basically, I have a service over http that takes http parameters and returns a singular response. http://localhost/myapp/helloname?fname= ... flintstone raw response: "hello fred flintstone" (no actual html, but it could). The above simplifies my challenge, but the two questions (that I would like an answer to both): 1) How can you load-test the above with SoapUI (testing SOAP/WSDL webservices already, and want to compare load differences with the SAME tool, to compare apples to apples, if possible). 2) The above demonstrates I want to have a small transport of data/need for marshall-demarshall/processing as possible. Is there a more formal/better approach over HTTP? thanks! -D p.s. first time using SoapUI, providing very easy to use and useful!.1.4KViews0likes1Comment