Transfer property value to request header in next step.

[pablofuentesbod]

Hi all,

I'm trying to transfer one property from one test step response to next step request.

I have managed to extract the property in a property called myproperty but now I need to use this property in an authentication header but using $myproperty in header value the value is not correctly set during testing.

please can you help me to set the header with the property value.

thanks in advance, Pablo.

[pablofuentesbod]

Hi,

attached the transfer screenshoot.

I have tested with both properties and with only one property and same issue.

any ideas ??

best regards, Pablo.

[nmrao]

@pablofuentesbod,
Am not sure if someone is not able to following the instruction mentioned in each of the reply, that is what I feel.

It has been asked to remove temp_property step.

In the property transfer step, Select TestCase as Target.

If the does not make sense, please ignore.

[pablofuentesbod]

Hi rao,

I tested with both and only one property and same results.

I can not set the property to otherthng that properties.myproperty ... nos possible to set to test case level.

any other ideas ??

best regards, Pablo.

[Daniel01]

Hi,

I have the same problem.

I added two screen dumps of my settings. Perhaps there is something wrong?

[nmrao · Accepted solution]

Hmm, really frustrating for both.

Step1:

Select test case name, and select custom tab and add property as mentioned and leave value blank (a Property Transfer step is going to write value for this )

Step 2 : Go to Property transfer step, make the changes as suggested in the image i.e., Select the test case for the target drop down and Select the Property name

Then remove the tem_property test step

Step 3:

[nmrao]

Please see the reply to the post. If you still have issue, then recommend you to open a new topic instead.

[pablofuentesbod]

Hi Rao,

thanks for your help and support, really appreciated.

the steps provided worked fine, I was not aware of the different levels setting the properties.

thanks for your help.

best regards, Pablo.

[nmrao]

@pablofuentesbod, glad to know and finally you could proceed.

[cmacktm1]

@pablofuentesbod,

Think I am not following this example well myself.  I need to transfer my header of bearer and then the access token and put both in the same value box.  Am I correct in assuming that this is what you were doing here.  If so can you can you share screen shots of you set up.   I am getting NULL in my transferred values.   thanks for your help..