Hi Abe,
Considering that "After the profiling run is over, AQtime displays detailed information about profiling results." (https://support.smartbear.com/viewarticle/54511/) I think that your expectation is correct.
I would suggest to try Troubleshooter first (https://support.smartbear.com/about-troubleshooter/) and contact Support via https://support.smartbear.com/message/?prod=AQtime form referencing this thread if Troubleshooter does not help.
I will appreciate if you update this thread with the result...
Hi,
I contacted support by raising a customer care ticket and got a solution which worked for me to get the results automatically when the profiled application closed.
This is why results weren't generating in the first place:
AQtime doesn't generate profiling results if your application crashes or terminates with a non-zero exit code. In this case, the application is not finalized correctly, so AQtime cannot collect profiling results properly.
However, AQtime has a mechanism to overcome the situation.
And below is the solution suggested:
Complete the following two steps:
1) Download and install the latest version of the tool. You can download AQtime 8.60 from AQtime's product page after you log in to the website using your registration information: https://my.smartbear.com/
2) Enable the Get results at early finalization phase option in the General Preferences dialog (Options | Options... | General | General Preferences) of AQtime.
I have AQtime 8.40 installed and I did the 2nd option. By doing this results were generated automatically.
Thank you for the support.
Regards,
Abe
Hi Abe,
Thank you a lot for the update!
(Need to go through documentation one more time to refresh my memory - 2nd option should definitely be described there...)
