Forum Discussion

Aleksi1's avatar
Aleksi1
Occasional Contributor
3 years ago
Solved

Add Build Number to a Test Execution

Hi all   When preparing a Test Cycle, we can define the "Version". This is also applied to all Test Cases. When executing a Test Case in a Test Execution, it can happen, that we receive a new Buil...
  • julian_palmer's avatar
    julian_palmer
    3 years ago

    We had this exact requirement as well. We got a workable solution with a custom field on executions.

    The one problem we have is that these custom fields cannot be marked mandatory. This means we are reliant on the test engineer remembering to add the build number. Experience is they often forget and then we lose traceability of what was tested on what build number.

julian_palmer's avatar
julian_palmer
Occasional Contributor
3 years ago

We had this exact requirement as well. We got a workable solution with a custom field on executions.

The one problem we have is that these custom fields cannot be marked mandatory. This means we are reliant on the test engineer remembering to add the build number. Experience is they often forget and then we lose traceability of what was tested on what build number.

  • Aleksi1's avatar
    Aleksi1
    Occasional Contributor
    3 years ago

    Did you add the Build Number/Custom Field to the Test Case or the Test Execution itself?

    If I go to "Tests > Configuration > CUSTOM FIELDS"  I can choose where to add the new custom field. And I saw, that I can make it mandatory by checking the checkbox "required".

     

    Best

    Aleks

    • Aleksi1's avatar
      Aleksi1
      Occasional Contributor
      3 years ago

      Ok, just saw what you already mentioned. The "required" checkbox is only available for custom fields for Test Cases - not for custom fields for Test Executions.

       

      Thank you anyway. I will use the same approach.