Forum Discussion
Toby_Hage
16 years agoOccasional Contributor
Hi Ole and Others,
Finally I understand what is happening.
When a datasource is used in a testcase. The testcase will never finish until the datasource is empty. So the test delay is not used in this case during a loadtest. Except between testcase 0 and testcase 1!!
If you want a delay you can add a teststep with a delay, as mentioned in the previous topic by Ole.
I thought that the testcase was finished after all teststeps were executed. But the datasource loop will prevent this.
When I remove the datasource loop, the testcase will finish when all teststeps are exectued. In this case what will happen with the datasource:
1) same record is used in next testcase execution?
or
2) next record is used in next testcase execution?
regards,
Toby.
Finally I understand what is happening.
When a datasource is used in a testcase. The testcase will never finish until the datasource is empty. So the test delay is not used in this case during a loadtest. Except between testcase 0 and testcase 1!!
If you want a delay you can add a teststep with a delay, as mentioned in the previous topic by Ole.
I thought that the testcase was finished after all teststeps were executed. But the datasource loop will prevent this.
When I remove the datasource loop, the testcase will finish when all teststeps are exectued. In this case what will happen with the datasource:
1) same record is used in next testcase execution?
or
2) next record is used in next testcase execution?
regards,
Toby.