Forum Discussion

Flora's avatar
Flora
New Contributor
6 years ago

How could be a good way to create a member which would be used in many test cases of a test suite?

I am just starting to use SoapUI recently. Can someone nicely help me figure out this problem? I have a method to create a member which would be used in many test cases of a test suite only. So won't...
  • Lucian's avatar
    Lucian
    6 years ago

    Something like jkrolczy should do the trick. However, I would advise using a Test Suite Setup script for this. So the scenario would look like this:

     

    1. Before a certain test suite is started, ReadyApi executes the Setup script (which generates the memberId and password and saves them at Test Suite level)

    2. Every Test Case references that memberId and password.

Lucian's avatar
Lucian
Community Hero

Hi Flora,

 

What do you mean by member? Can you tell a little bit more about what you're trying to do?

Flora's avatar
Flora
New Contributor
6 years ago

Hi Lucian ,

 

Thank you for your reply!

 

Sure! For example, I have a method to generate a memberID and password so that I can login using them to check some functionalities. 

 

I have a test suite which includes a few test cases and all of those cases have the same step: generate a new memebrID, pwd and login.

 

My question is that is there a better way to generate the memberID in the test suite level so that all the cases under that test suite can use the memberID? 

  • jkrolczy's avatar
    jkrolczy
    Regular Contributor
    6 years ago

    You could create a test case in your TestSuitte that would generate a memberID and password.

    This would be the first testcase to run in your suite.

    Not sure how you are creating these new memberID and Pwd ??

     

    TestSuite level : Custom Properties: create variables   i.e.  memberID and Pwd

     

    Using Groovy script in this test cases you can extract these from a Response

    or however you know these values

    Then store them into a TestSuite: Custom Properties variables   i.e.  memberID and Pwd

     

    testRunner.testCase.testSuite.project.setPropertyValue( "memberID ", <your value>);
    testRunner.testCase.testSuite.project.setPropertyValue( "Pwd", <your value>);

     

    Then in the following test cases where you need these values, refernce your TestSuite level

    using this in the appropiate spot for your memberID  or Pwd

     

    ${#TestSuite#memberID}

    ${#TestSuite#Pwd}

     

     

    • Flora's avatar
      Flora
      New Contributor
      6 years ago

      Hi jkrolczy ,

       

      Thank you for your reply. My concern is how could we guarantee the test case we used to generate memberID can be run firstly? I think they were run simultaneously.