Forum Discussion

JeffSm's avatar
JeffSm
Contributor
6 years ago

request parameters not appearing in SoapUI Pro

I create a resource in the Projects tab, with a parameter.  I add to Test Case, but the parameter table is empty.  It says to use the project tool to add request parameters.  There is already a param...
  • richie's avatar
    richie
    6 years ago

    Hi JeffSm 

     

    I have had exactly the same behaviour occur when creating test steps.

     

    What I found was that occasionally making a change in the UI wasn't persisted properly - i.e. add a query parm in the 'Projects' section of ReadyAPI!, navigate to the SoapUI tab and create a request based on the resource created in Projects, but the parms on the step are empty or the values were blank despite I thought I'd set them correctly.

     

    What I noticed was that after I'd made the change in the Projects section (i.e. add in a query parm on the REST request whether at Resource or Method level) I moved the focus out of the field to a different field to ensure the value remained.  At this point I selected to Save all changes on the project.  I then continued to make the required changes - each time ensuring teh changes remained and I saved those changes.

     

    hope this helps,

     

    richie

     

     

HimanshuTayal's avatar
HimanshuTayal
Community Hero

JeffSm ,

 

Can you please add any screenshot of the error.

 

 

richie's avatar
richie
Community Hero
6 years ago

Hi JeffSm 

 

I have had exactly the same behaviour occur when creating test steps.

 

What I found was that occasionally making a change in the UI wasn't persisted properly - i.e. add a query parm in the 'Projects' section of ReadyAPI!, navigate to the SoapUI tab and create a request based on the resource created in Projects, but the parms on the step are empty or the values were blank despite I thought I'd set them correctly.

 

What I noticed was that after I'd made the change in the Projects section (i.e. add in a query parm on the REST request whether at Resource or Method level) I moved the focus out of the field to a different field to ensure the value remained.  At this point I selected to Save all changes on the project.  I then continued to make the required changes - each time ensuring teh changes remained and I saved those changes.

 

hope this helps,

 

richie