Forum Discussion

bobkaiser's avatar
bobkaiser
New Contributor
12 years ago

LoadUI Table Log - Missing Incoming Messages

I am running LoadUI 2.6.8 on a Windows 7 - 64bit system. When I connect a Table Log component to some source component, I get no incoming messages displayed in the Table Log component. This occurs for several different source components including SoapUI Runner, Web Page Runner, or Process Runner.

Example: Process Runner / ping yahoo.com with the Process Runner lower left-hand output circle connected to the top circle of the Table Log component. Using Run Once, Process Runner shows request completed. No results are displayed in the Table Log.

I have installed both LoadUI and LoadUI 64-bit in c:\dev\SmartBear\LoadUI-2.6.8 and c:\dev\SmartBear\LoadUI-2.6.8-64bit directories respectively. Both 32-bit and 64-bit versions of LoadUI give the same results. What do I need to check?

1 Reply

  • bobkaiser's avatar
    bobkaiser
    New Contributor
    12 years ago
    After further testing with running a load, I found that the Table Log component does display results after several requests are completed. It appears that the display waits for the buffer to partially fill. Run Once on a Process Runner ping command did not show results after about 25 runs. When I ran the Process Runner ping via the Play button and a Fixed Rate generator, I started seeing results after about 20 requests.

    A nice feature would be to have a flush button on the Table Log which would display Results from the partially-filled buffer.