Load UI summary
Hi, I ran a distributed load test and from the summary it wasn't showing correct numbers. The test contained 3 scenarios. A scenario contains a generator (30/s), a soap ui runner and 3 logs co...
Forum Discussion
Hi Max,
1. Please see attached screenshot where numbers arent matching. Scenario 2 and did not have any counts for each step.
2. All runner had table logs attached but I missed the enabled in distributed mode so that was probably why it didnt show.
3. How do we know if it is case 2? The tested server was being monitored for processor time but it was mostly in the 50 %. It did reach 100 % a few times. It was being run with 10 agents and the max concurrent users and queues were increased prior to testing.
4. Thanks. I had missed this part.
5. Do you mean all 60k requests failed (apart from the assertion fails from soap ui)? Why would this be?
Thanks.
1. Please see attached screenshot where numbers arent matching. Scenario 2 and did not have any counts for each step.
2. All runner had table logs attached but I missed the enabled in distributed mode so that was probably why it didnt show.
3. How do we know if it is case 2? The tested server was being monitored for processor time but it was mostly in the 50 %. It did reach 100 % a few times. It was being run with 10 agents and the max concurrent users and queues were increased prior to testing.
4. Thanks. I had missed this part.
5. Do you mean all 60k requests failed (apart from the assertion fails from soap ui)? Why would this be?
Thanks.
