Error on summary reports

Hi!

What does the Project > Completed > Total statistic say if you add it to a chart?

What would be best is if you could send us the project and test run to our support form (or attach here) so that we can have a look at it.

Btw, did you abort the request?

Regards

Henrik O
SmartBear Software

Hi Henrick,

I added the total completed stadistics to my chart as you said and I think I found the problem

Report shows the test had a duration of 1:10 minutes but my service has a 48 sec avg response time, so, if I can understand the summary report only has the data of that specific time because after the test is completed some requests are still running.

how can i solve it?

I attached the chart.

Regards.

Hello,
If you are stopping the running requests when the tests ends(see picture) then the aborted requests will not be on the summary report.

Try to wait for the requests to finish when the test ends and see if it will work.

Regards,
Max

Hi MaximilianSkog,

I let the test completely finished and did not press the abort button.

Hi again
Hmm, this proved to be hard to reproduce. Could you please send us your SoapUI project and LoadUI project so we can have a closer look at this?

Thanks,
Max

Hello,

I have the same problem !! Have you managed to make it show you all the requests in the report?

I am sending 600 requests in 11 minutes and I set up the Time Limit to 20 minutes - hopping I can have all my requests in the report this way.
It didn't work. When all the 600 requests were sent, the test stopped (I haven't pressed the Abort test running requests button).
I waited for all the Runnig requests to be completed, but no luck.

Please help!
Thank you.
Andreea