Forum Discussion

armygrad's avatar
armygrad
Contributor
3 years ago
Solved

data source Loop

Hi

 

I have set the Data source to loop 10 times but it only does 7

 

armygrad_0-1675093213478.png

What am i doing Wrong

 

Thanks in advance

data-driven testing
  • SarahS's avatar
    SarahS
    3 years ago

    Hi armygrad, 

    There's not a lot of information here, but if I had to guess I would say your test case is aborting on error and an error is occurring on data loop 7. 

    If this is the case then you can un-check the option for aborting the test case on failure in your test case options. 

    SarahS_0-1675095776532.png

    Or you can go to Preferences and apply this for all your test cases by default.

    SarahS_1-1675095903646.png

    If this isn't the issue could you provide some additional information? It might  be helpful to see whats happening in the transaction log around loop 7. 

     

2 Replies

  • SarahS's avatar
    SarahS
    Icon for Staff rankStaff
    3 years ago

    Hi armygrad, 

    There's not a lot of information here, but if I had to guess I would say your test case is aborting on error and an error is occurring on data loop 7. 

    If this is the case then you can un-check the option for aborting the test case on failure in your test case options. 

    SarahS_0-1675095776532.png

    Or you can go to Preferences and apply this for all your test cases by default.

    SarahS_1-1675095903646.png

    If this isn't the issue could you provide some additional information? It might  be helpful to see whats happening in the transaction log around loop 7. 

     

  • JoostDG's avatar
    JoostDG
    Frequent Contributor
    3 years ago

    Hi armygrad . Just a guess, but if each loop takes around 8 seconds then your test case will time out if you use the default setting (=0 == 60000 ms === 1 minute). So after 7 loops ReadyAPI will cancel the run as 1 minute has passed since you started the test case.

    You can adjust the Test Case Timeout via right click on the test case and click on options.

    JoostDG_0-1675096154528.png

    If that is not the root cause, potentially there might be something in your data source that is not as expected (check perhaps your error log and/or do some scripting to the script log (log.info) to see more details...